Product/Service

ABS Cellular Core DWV System

Source: Charlotte Pipe And Foundry
This specification covers ABS cellular core (foam core) pipe and ABS DWV solvent cement fittings used in sanitary drain, waste, and vent
Suggested Specification

System: ABS Cellular Core (Foam Core) Pipe and ABS DWV Fitting System

Scope: This specification covers ABS cellular core (foam core) pipe and ABS DWV solvent cement fittings used in sanitary drain, waste, and vent (DWV), sewer, and storm drainage applications. This system is intended for use in non-pressure applications where the operating temperature will not exceed 180°F.

Specification: Pipe shall be manufactured from virgin rigid ABS (acrylonitrile butadiene styrene) compounds with a Cell Class of 42222 as identified in ASTM D-3965. Fittings shall be manufactured from virgin rigid ABS compounds with a Cell Class of 32222 as identified in ASTM D-3965.

ABS cellular core pipe shall be Iron Pipe Size (IPS) conforming to ASTM F-628. ABS DWV solvent cement fittings shall conform to ASTM D-2661. Pipe and fittings shall be manufactured to the nominal dimensional standard, and shall be made by one manufacturer. Fittings shall be injection molded. Fabricated fittings shall not be permitted. All pipe and fittings shall be manufactured in the United States. All systems shall utilize a separate waste and vent system. Pipe and fittings shall conform to National Sanitation Foundation Standard 14.

Installation shall comply with the latest installation instructions published by Charlotte Pipe and Foundry and shall conform to all local plumbing, fire, and building code requirements. Solvent cement joints shall be made with a solvent cement conforming to ASTM D-2235. The system shall be protected from chemical agents, fire stopping materials, thread sealant, or other aggressive chemical agents not compatible with ABS compounds. Systems shall be hydrostatically tested after installation. Testing with compressed gas is not recommended.

Product Offering:
Pipe, 1-1/2" – 6"
Fittings, 1-1/2" – 6"

Referenced Standards: ASTM D-3965
Rigid ABS Compounds
ASTM F-628
Co-extruded ABS Pipe with Cellular Core
ASTM D-2661
ABS Drain, Waste, and Vent Pipe & Fittings
ASTM D-2235
Solvent Cements for ABS Pipe and Fittings
NSF Standard 14
Plastic Piping Components and Related Materials

Note: Latest revision of each standard applies

Charlotte Pipe And Foundry, P.O. Box 35430, Charlotte, NC 28235. Tel: 800-438-6091; Fax: 888-577-3649.